The compensatory tank for a brake liquid is located in a motor compartment. The tank stopper is equipped by a ventilating aperture which should not be corked.
The tank has the transparent case and consequently level of a brake liquid can be supervised outside.
Level of a brake liquid should be always more close to a label the MOVE.
If level of a brake liquid too low, before removal of a stopper from a compensatory tank wipe pure rags a stopper and a place about a stopper from pollution to avoid their hit in a hydraulic contour of brakes and coupling.
Add a brake liquid of the recommended mark in a tank. Mixing of various types of a brake liquid can damage hydraulic system.
Fill a tank with a brake liquid only to a dotted label. It will provide normal level at installation on a tank of a stopper with a float for the level control.
The brake liquid used in hydraulic system of brakes, is poisonous, therefore at its hit on a skin it is necessary to wash off immediately its considerable quantity of water.
If the liquid on imprudence has got to eyes or in an organism, immediately address to the doctor.
The brake liquid dissolves a paint and plastic, therefore at liquid hit on a paint and varnish covering of the car wash out its considerable quantity of water.
The brake liquid гигроскопична, that is absorbs a moisture from air, therefore it is not recommended to use a liquid, stored long time in open ware.
The brake liquid should not contact with mineral oils. Even the small amount of mineral oil worsens properties of a brake liquid and can put out of action brake system.
At the removed cover examine internal surfaces of a compensatory tank. If on tank walls there are adjournment or there are water droplets, replace a brake liquid.
After tank filling check up that the cover is reliably fixed on a tank.
Level of a brake liquid can slightly decrease at operation of the car owing to deterioration of brake overlays and automatic control brake pads. This quite normal phenomenon.
If level of a brake liquid has considerably decreased for short term or became below label MIN tightness of brake system, most likely, is broken. About too low level of a brake liquid in a tank the control lamp signals.