THE NOTE
Recommended periodicity: each 50 000 km of run or 24 months.
|
THE NOTE
Some filters represent screens with apertures which can be cleared by solvents, instead of be replaced.
|
THE PREVENTION
The oil temperature in a transmission can reach temperatures 170 С, therefore it is necessary to use protective gloves.
|
Oil replacement in an automatic transmission make right after trips. Hot oil is more effective, than cold, allows to remove from a transmission the deposit formed in it.
Lift the car on the lift.
|
Fig. 2.41. A reversing of a stopper plum of oil from an automatic transmission
|
Establish capacity for oil gathering under a drain stopper in the pallet of an automatic transmission. Turn out a drain stopper (
fig. 2.41). After oil plum establish a stopper into place and tighten the moment 17,6
Nm on cars till 2001 or the moment 47,4
Nm on cars since 2001.
|
Fig. 2.42. A reversing a key on 10 mm (1) stoppers plum of a liquid from back main transfer on cars since 2001 and on cars 2WD
|
On cars since 2001 and on cars 2WD also there is a drain stopper of back main transfer. Move capacity for oil gathering under a drain stopper of back main transfer and turn out a drain stopper (
fig. 2.42). After oil plum establish a stopper into place and tighten the moment 54
Nm.
Turn out lobbies and loosen the back bolts of fastening of the pallet of an automatic transmission. An edge of a screw-driver or mount reject передную a part of the pallet from картера an automatic transmission and merge the oil which has remained in the pallet. Turn out back bolts of fastening of the pallet and remove it.
|
Fig. 2.43. A reversing of a bolt of fastening of the filter of a liquid of an automatic transmission
|
Turn out bolts of fastening of the filter, release clips (on some models) and remove the filter (
fig. 2.43). At filter removal be careful, as at it there is a residual liquid.
Establish new (or washed out) the filter, fix its clips and bolts, having tightened their moment 9,5 Nm.
Carefully clear привалочные surfaces of the pallet and картера an automatic transmission.
|
Fig. 2.44. An arrangement of magnets on the pallet of an automatic transmission
|
Note an arrangement of magnets on the pallet, remove and clear them. Wash up the pallet in pure solvent, dry up its stream of compressed air and establish into place magnets (
fig. 2.44).
Establish the pallet with a new lining on картер transmissions and fix bolts.
Lower the car.
Through directing tube of the index of level of oil of an automatic transmission fill in fresh oil. Fill in oil in the small portions, thus constantly checking its level.
Get the engine, tighten a lay brake and move the lever of the selector from position Р to position L, for a short while detaining him in intermediate positions, then again in River position
At engine work on frequency of rotation of idling check up oil level in an automatic transmission. Add oil to the top label corresponding to a cold transmission.