Use only fresh brake liquid DOT 4.
Uncover a tank with a brake liquid.
Syringe pump out a brake liquid from a tank.
Fill a tank with a fresh brake liquid to exclude air hit in brake system from a tank. Watch that level of a brake liquid was in a tank not below mark MIN during procedure carrying out.
Replacement of a brake liquid make for each branch hydraulic a kennel in the same sequence, as air removal.
Remove a dustproof cap from the union of prorolling of a forward left support, clear it and put on it one end of a pure transparent hose, its other end lower in the capacity partially filled with a brake liquid. The capacity should be not less than on 300 mm above the prorolling union. Thanks to it air hit in a support through a carving of the union of prorolling is prevented.
Sharply press a pedal of a brake of 3-5 times with an interval 2–3 with, turn out on a half-turn the prorolling union at the pressed pedal. Continuing to press a pedal, supersede an old brake liquid being in a contour through a hose in capacity. After the pedal will reach extreme bottom position and вытекание liquids through a hose will stop, wrap the prorolling union to the full. Release a brake pedal that she has returned to a starting position.
Repeat these operations while the prorolling union will not leave a fresh brake liquid.
THE PREVENTION
During operations on replacement of a brake liquid watch level of a brake liquid in a tank.
|
Keeping a pedal in the pressed position, wrap the prorolling union against the stop and remove a hose.
Wipe the union of prorolling and establish a protective cap.
THE NOTE
Recommended periodicity: each 50 000 km of run or 24 months.
|
THE NOTE
On cars, since 2001, the fuel filter is an integral part of the block of the fuel pump established in a fuel tank. Its periodic replacement is not provided.
|
Repeat these operations for hydraulic contours of other wheels.