|
PREVENTIONS
Do not suppose hit of a cooling liquid on clothes and a paint and varnish covering of a body. Otherwise wash out a surface a water considerable quantity.
Collect and utilise the merged cooling liquid.
|
The liquid system of cooling of the engine closed, has the broad tank located in front at the left in a motor compartment as a compensatory element. The broad tank is connected by a hose to the basis of a jellied mouth of a radiator. At engine work the cooling liquid at the expense of heating extends, and the liquid part through шлаг gets to a broad tank. At cooling of the engine the volume of a cooling liquid decreases, and it from a broad tank comes back in cooling system, providing an optimum level.
Regularly check level of a cooling liquid. It should be between labels FULL and LOW on a broad tank. Liquid level changes depending on engine temperature. At the cold engine level should be about label LOW or hardly above it. After warming up of the engine level should be about label FULL or hardly below it. Otherwise remove a stopper from a broad tank and add cooling liquid. Use only cooling liquid on a basis этиленгликоля and the distilled water. Do not use additional ингибиторные and other additives. If the small quantity of a cooling liquid is required only, it is possible to add the pure distilled water.
Do not pour cooling liquid above mark FULL: the superfluous liquid at expansion will follow from cooling system through a safety valve located in a stopper.
Fast falling of level of a cooling liquid specifies in a leak and necessity of its elimination. Check up a condition of a radiator, the water pump, hoses, connections and stoppers plum on presence on them of traces подтекания. If leaks are not found out, check up at servicing deport pressure of opening of the valve in a radiator cover.
At the big loss of a cooling liquid add it only after engine cooling to avoid its exit out of operation because of sharp cooling.
|
THE PREVENTION
At opening of a cover of a radiator on the hot engine be careful, as leaving steams can lead to strong burns. Close a radiator cover a thick layer of a fabric and slowly turn away a cover to a hissing sound. After the hissing termination slowly turn on and uncover a radiator.
|
At check of level of a cooling liquid check up its condition. The liquid should be pure and transparent. If the cooling liquid has brown colour or colour of a rust, merge a liquid, wash out system of cooling and fill in a fresh cooling liquid.
Without fail change cooling liquid after carrying out of any works on elements of system of cooling with сливом a cooling liquid. If at repair the head of the block of cylinders, linings of a head of the block, a radiator or the oil heat exchanger was replaced, fill in in cooling system a fresh cooling liquid. It is connected by that the anticorrosive additive in a cooling liquid at engine work is besieged and creates anticorrosive protection. In the cooling liquid which were in operation, anticorrosive additives are insufficiently active to form a protective layer on again established details.