Тойота РАВ4-Toyota RAV4
1. Car operation
2. Maintenance service
3. Engines
   Engine repair 3S-FE without its removal from the car
      The general data
      Installation of the piston of the first cylinder in the top dead point (ВМТ)
      Cover of a head of the block of cylinders
      Inlet collector
      Final collector
      Gear belt and pulleys of a gear belt
      Forward sealing ring of a cranked shaft
      Sealing ring of a camshaft
      Camshafts and pushers of valves
      Head of the block of cylinders
      The oil pallet
      The oil pump
      Flywheel / a drive plate
      Back sealing ring of a cranked shaft
      Support of the power unit
   Engine repair 1AZ-FE without its removal from the car
   Diagnostics and preparation of the engine for major repairs
4. Cooling and air-conditioning systems
5. Fuel system and system of release of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. A transmission
10. A kardannyj shaft and shaft of a drive of driving wheels
11. Brake system
12. A suspension bracket
13. A steering and a running gear
14. A body
15. An electric equipment
Electric equipment schemes

Toyota RAV4>> Engines>> Engine repair 3S-FE without its removal from the car>> The general data
This section is devoted engine repair 3S-FE, established in a motor compartment. The engine was established on cars till 2001.
Before work on the engine, clear a motor compartment and the engine degreasing means. It considerably will facilitate performance of any works.
For access improvement to the engine it is desirable to remove a cowl. Capes protect wings to prevent damage of a paint and varnish covering.
On the engine established in the car, it is possible to adjust, remove, check up, replace and establish following details, knots and units:
– Inlet and final collectors;
– Linings of inlet and final collectors;
– The oil pallet;
– A lining of the oil pallet;
– Sealing rings of a cranked shaft;
– A head of the block of cylinders;
– A lining of a head of the block of cylinders;
– The oil pump;
– The water pump;
– A starter;
– The generator;
– Knots of fuel system;
– Camshafts;
– To adjust backlashes of valves;
поликлиновые belts of a drive of hinged units;
– A gear belt;
– Pulleys;
– Support of the power unit;
– A drive flywheel/plate.