Тойота РАВ4-Toyota RAV4
1. Car operation
2. Maintenance service
3. Engines
   Engine repair 3S-FE without its removal from the car
      The general data
      Specifications
      Installation of the piston of the first cylinder in the top dead point (ВМТ)
      Cover of a head of the block of cylinders
      Inlet collector
      Final collector
      Gear belt and pulleys of a gear belt
      Forward sealing ring of a cranked shaft
      Sealing ring of a camshaft
      Camshafts and pushers of valves
      Head of the block of cylinders
      The oil pallet
      The oil pump
      Flywheel / a drive plate
      Back sealing ring of a cranked shaft
      Support of the power unit
   Engine repair 1AZ-FE without its removal from the car
   Diagnostics and preparation of the engine for major repairs
4. Cooling and air-conditioning systems
5. Fuel system and system of release of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. A transmission
10. A kardannyj shaft and shaft of a drive of driving wheels
11. Brake system
12. A suspension bracket
13. A steering and a running gear
14. A body
15. An electric equipment
Electric equipment schemes




Toyota RAV4>> Engines>> Engine repair 3S-FE without its removal from the car>> Final collector
Removal
Removal of a final collector spend on the cold engine in a following order:
– Switch off ignition and disconnect a wire of "weight" from the storage battery;
– Release from clips of a wire of the gauge of oxygen. If the new final collector is established, remove the oxygen gauge.

Fig. 3.8. An arrangement of bolts of fastening of a thermofilter of a final collector


– Turn out bolts (fig. 3.8) and remove a thermofilter of a final collector;
– Put on nuts of fastening of a final collector the means facilitating them отворачивание;
– Disconnect a reception exhaust pipe from a final collector;

Fig. 3.9. An arrangement of a nut and a bolt of fastening of a support of a final collector about a forward support of the engine


– Turn out nuts and bolts (fig. 3.9) and remove a support of a final collector. On some models are established on two support of a final collector;

Fig. 3.10. An arrangement of nuts of fastening of a final collector to a head of the block of cylinders


– Turn out nuts (fig. 3.10) and remove a final collector and a lining.
Installation
Installation make in a following order:
– A scraper remove the rests of an old lining and adjournment of soot with привалочных surfaces of a final collector and a head of the block of cylinders;
– Establish a new lining of a final collector on hairpins of a head of the block of cylinders;
– Establish a final collector and fix its nuts. Tighten nuts in some approaches, since the centre and further on a spiral.
The further installation is spent to sequences, return to removal.
Start up the engine and check up on absence of leaks of the fulfilled gases.