Replacement make in a following order:
– Remove a gear belt, a tension roller and a pulley of a gear belt from a camshaft;
– Remove a back casing of a gear belt;
|
|
Fig. 3.24. Use of a screw-driver for removal of a sealing ring of a camshaft
|
– A screw-driver edge take a sealing ring from a nest (
fig. 3.24);
– At removal do not scratch a nest of a sealing ring and a camshaft;
– Clear a nest of a sealing ring and a neck of a cranked shaft. Grease with engine oil an external surface and a working edge of a sealing ring;
– Tubular оправкой, with external diameter a bit smaller external diameter of a ring, establish a sealing ring into place. Check up that the ring is established without a warp and on the same depth, as earlier established ring;
– Establish a back casing of a gear belt, a pulley of a camshaft and a gear belt;
– Start up the engine and check up tightness of a sealing ring of a camshaft.