As practice, lobbies brake pads from outside shows the passenger wear out most intensively, therefore and to check brake pads it is necessary on the right forward wheel.
Loosen the bolts of fastening of the right forward wheel also include a lay brake, then lift передную a part of the car and fix on supports. Remove the right forward wheel.
|
Fig. 2.19. An aperture on a support of disk brakes for the control brake pads
|
On disk brakes in each support are established on 2 brake
pads. Internal brake
pads are visible through viewing apertures in each support (
fig. 2.19). External brake
pads are visible sideways a support. Visually define a thickness brake
pads.
If it is visually difficult to define a thickness brake pads or there is a suspicion on an unsatisfactory condition pads, remove them for the further survey. If the overlay brake pads is worn out till the minimum thickness, replace all four brake pads in the complete set.
By calliper measure a thickness of a brake disk. If a thickness of a disk less maximum permissible, replace it. Also check up a condition of a brake disk on absence of cracks and задиров.
Before wheel installation check up a condition of brake hoses and tubes.
Establish a wheel and lower the car.