Switch off ignition and disconnect a wire of "weight" from the storage battery.
Chalk, marker or paint note a rotation direction поликлинового a belt. If at installation поликлиновой the belt rotates in other party, it can lead to its destruction.
Cars of release till 2001
Loosen the a tension also remove a belt from pulleys, since a pulley of a cranked shaft. At replacement of a belt of a drive of the pump of the amplifier of a steering preliminary it is required to remove a belt of a drive of the compressor of the conditioner.
Fig. 2.15. An arrangement поликлинового a belt on engine pulleys: And — it is correct; In — it is wrong
After belt replacement check up that the belt is correctly located on engine pulleys (fig. 2.15
Adjust a belt tension.
Cars of release since 2001
Fig. 2.16. Tension easing поликлинового a belt on cars since 2001: 1 – шестигранник the tension mechanism
Establish накидной a
key on шестигранник the
tension mechanism, turn it clockwise for easing of a tension of a belt, and remove a belt from pulleys (fig. 2.16
). Slowly release the mechanism of a tension of a belt.
Again a key turn the tension mechanism clockwise and establish a new belt on engine pulleys, then smoothly release the tension mechanism.
Check up that the belt is correctly located on engine pulleys (fig. 2.15
Connect "a weight" wire to the storage battery.