Removal of the switch of a heater of back glass on models till 2001 make as follows.
Using a screw-driver edge as the lever, separate the switch of a heater of back glass and take it from the panel of devices.
Disconnect an electric socket, wring out a clamp and take the switch from a casing.
Switch removal
Heater of back glass
On models since 2001
It is made as follows.
|
|
Fig. 14.51. An arrangement of screws of fastening of the central overlay of the panel of devices on models since 2001
|
Turn out screws and remove the central overlay from the panel of devices (
fig. 14.51 see
).
|
|
Fig. 15.25. An arrangement of screws of fastening of the block of management of a heater
|
Turn out screws and extend from the panel of devices the block of management of a heater, then disconnect an electric socket from a back part of the switch (
fig. 15.25 see
). Wring out a clamp and take the switch from the holder.
Installation of the switch of a heater of back glass of both types make in sequence, return to removal.