Removal of the switch of the emergency light alarm system on models till 2001 make as follows:
|
|
Fig. 15.24. Use of a screw-driver for branch from the panel of devices of the switch of the emergency light alarm system
|
Using a screw-driver edge as the lever, separate the switch of the emergency light alarm system and take it from the panel of devices (
fig. 15.24).
Disconnect an electric socket, wring out a clamp and take the switch from a casing.
Switch removal
The emergency light alarm system
On models since 2001
It is made as follows.
|
|
Fig. 14.51. An arrangement of screws of fastening of the central overlay of the panel of devices on models since 2001
|
Turn out screws and remove the central overlay from the panel of devices (
fig. 14.51 see
).
|
|
Fig. 15.25. An arrangement of screws of fastening of the block of management of a heater
|
Turn out screws and extend from the panel of devices the block of management of a heater, then disconnect an electric socket from a back part of the switch (
fig. 15.25). Wring out a clamp and take the switch from a casing.
Installation of the switch of the emergency light alarm system make in sequence, return to removal.