Тойота РАВ4-Toyota RAV4 1. Car operation 2. Maintenance service 3. Engines 4. Cooling and air-conditioning systems 5. Fuel system and system of release of the fulfilled gases 6. Ignition system 7. The monitoring system and decrease in toxicity of the fulfilled gases 8. Coupling 9. A transmission 10. A kardannyj shaft and shaft of a drive of driving wheels 11. Brake system 12. A suspension bracket 13. A steering and a running gear 14. A body 15. An electric equipment    The general data    Technical characteristics    Electric chains    Check of the storage battery    Replacement of wires of the storage battery    Safety locks and the relay    Check and replacement of the relay of indexes of turn and the emergency light alarm system    Check of system of gymnastics    The generator    System of start-up of the engine    Replacement combined подрулевых switches    Replacement of the lock and the cylinder of the lock of ignition    Removal and installation of switches of the panel of devices    Removal and installation of a combination of devices    Check and replacement of the engine of a screen wiper    Radio receiver and dynamics    Aerial replacement    Check and repair of a heater of back glass    Replacement of lamps in headlights    Adjustment of light of headlights    Headlight replacement    Sound signal    Replacement of lamps накаливания    Check of a drive of external rear-view mirrors    Check of system of the cruise-control    Check стеклоподъемников with an electric drive    Check of system of the central blocking of locks    Drive podemno-sdvizhnoj roof panels    Safety pillows Electric equipment schemes Toyota RAV4>> Electric equipment>> Replacement of wires of the storage battery Periodically examine on all length the wires connected to the storage battery, on absence of the damages damaged and burnt through isolation and corrosion. The unreliable connection of wires increasing resistance of contact, will reduce size of the current consumed by a starter, and it will create difficulties at engine start-up. Check up clips on the ends of wires on absence of corrosion. Presence of white flakes under isolation testifies that the wire has undergone to influence of corrosion and it is necessary to replace it. Check up clips on absence of the deformation reducing a stain of contact to the plug of the storage battery. Replacement of wires of the storage battery make as follows: At first disconnect a wire from the negative plug of the storage battery, take him aside and isolate for an exception of casual connection to the storage battery.        THE PREVENTION Even if it is necessary to replace only a wire connected to the positive plug, first of all disconnect a wire from the negative plug of the storage battery. After a detachment of wires from the storage battery, disconnect them from opposite sides. Fig. 15.1. A place of connection of a "mass" wire to a car body Disconnect wires from the traction relay of a starter, the block of safety locks and "mass" wires from a body and the power unit (fig. 15.1). Note an arrangement of each wire to guarantee correct installation of a new wire. At replacement of wires use new wires with the same sections and length as replaced. Positive wires of usually red colour also have большее section (diameter), and negative — black colour and their section is less, than positive wires. Wire brush clear carving contact of the traction relay of a starter. For protection against corrosion apply a thin film technical vaseline on plugs of the storage battery. Fix on new wires clips for connection to plugs of the storage battery and fix their bolt and a nut, having tightened them it is very reliable. Before connection of a new wire to the storage battery be convinced that the wire will not be tense. After installation of new wires connect "a weight" wire to the negative plug of the accumulator.