Тойота РАВ4-Toyota RAV4
1. Car operation
2. Maintenance service
3. Engines
4. Cooling and air-conditioning systems
5. Fuel system and system of release of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. A transmission
10. A kardannyj shaft and shaft of a drive of driving wheels
11. Brake system
12. A suspension bracket
13. A steering and a running gear
14. A body
15. An electric equipment
   The general data
   Technical characteristics
   Electric chains
      Detection of damages to a chain
      Electric sockets
   Check of the storage battery
   Replacement of wires of the storage battery
   Safety locks and the relay
   Check and replacement of the relay of indexes of turn and the emergency light alarm system
   Check of system of gymnastics
   The generator
   System of start-up of the engine
   Replacement combined подрулевых switches
   Replacement of the lock and the cylinder of the lock of ignition
   Removal and installation of switches of the panel of devices
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and dynamics
   Aerial replacement
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Headlight replacement
   Sound signal
   Replacement of lamps накаливания
   Check of a drive of external rear-view mirrors
   Check of system of the cruise-control
   Check стеклоподъемников with an electric drive
   Check of system of the central blocking of locks
   Drive podemno-sdvizhnoj roof panels
   Safety pillows
Electric equipment schemes

Toyota RAV4>> Electric equipment>> Electric chains>> Electric sockets
The majority of connections in an electric network of the car is executed by multicontact sockets in the plastic case. Sections (half) of sockets after connection are usually kept by the clamps cast in the case of a socket.
Sections of the big sockets, for example, devices established under the panel, incorporate together the screw passing through the centre of a socket.
To disconnect a socket with a clamp, a small screw-driver wring out a clamp (), then disconnect demanded section of a socket. Attentively examine a socket as it is frequent clamps of sockets are imperceptible at first sight. Many sockets have on нескольку clamps.

At separation of a socket do not pull socket section every which way for wires as it is possible to damage or pull out wires from clips of contacts of a socket.