Removal of the external handle and the cylinder of the lock of a door make as follows:
Lift against the stop door glass, then remove an upholstery and пылевлагозащитную a film from a door.
Not to scratch a paint and varnish covering of a door, paste on a door about the handle a sticky tape.
Through an aperture in the internal panel of a door release plastic clips and disconnect draughts from the external handle of a door and the lock cylinder.
On models till 2001 further operate as follows:
– Turn out bolts of fastening of the handle and remove from a door the external handle together with the lock cylinder;
– Remove a clip and take the cylinder of the lock from the handle.
On models since 2001 operate as follows:
|
|
Fig. 14.31. Removal заглушки from an end face of a door for access to the screw of fastening of the cylinder of the lock of a door on models since 2001
|
|
|
Fig. 14.32. Removal of the cylinder of the lock from a door on models since 2001
|
– Remove
заглушку from a door end face, turn out the screw of fastening and remove the cylinder of the lock from a door (
fig. 14.31,
14.32);
|
|
Fig. 14.33. An arrangement of bolts of fastening of the external handle to a door on models since 2001
|
– From the interior of a door turn out a bolt and remove the external handle from a door (
fig. 14.33).
Installation make in sequence, return to removal.