|
THE PREVENTION
Cars are equipped by safety systems (SRS), including pillows of safety and натяжителей seat belts. Before work about gauges of blow, the panel of devices and a steering column disconnect at first negative, and then positive the plug from the storage battery and wait 2 minutes It will exclude unapproved disclosing of pillows of safety and operation натяжителей seat belts which can put physical injuries.
|
Removal of the central console make as follows:
Switch off ignition and disconnect a wire of "weight" from the storage battery.
Lift the lever of a lay brake.
If the car is equipped by a mechanical transmission, turn away the button from the lever of a gear change and remove a cover of the lever of a gear change.
|
|
Fig. 14.45. Removal of a decorative overlay of the lever of the selector on cars since 2001, equipped with an automatic transmission
|
If the car is equipped by an automatic transmission, remove a decorative overlay of the lever of the selector (
fig. 14.45).
On models since 2001 turn out screws and a screw-driver edge separate the bottom part of the central decorative overlay of the panel of devices. Not to scratch the panel, wind an edge of a screw-driver with a sticky tape or rags.
On models till 2001 turn out screws of a forward and average part of the central console, then turn out the screw of fastening of a back part and, moving the console, remove it back.
|
|
Fig. 14.46. An arrangement of screws of fastening of back section of the central console on models since 2001
|
|
|
Fig. 14.47. An arrangement of a cover of furnish in forward section of the central console on models since 2001
|
On models since 2001 turn out screws and remove back section of the central console (
fig. 14.46). Also remove furnish covers in forward section of the central console (
fig. 14.47).
|
|
Fig. 14.48. An arrangement of screws of fastening of forward section of the central console on models since 2001
|
Turn out screws of fastening of forward section of the central console and remove it on the lever of a lay brake (
fig. 14.48).
Disconnect from forward section of the central console electric sockets and remove it from the car.
Installation of the central console make in sequence, return to removal