|
THE PREVENTION
Cars are equipped by safety systems (SRS), including pillows of safety and натяжители seat belts. Before work about gauges of blow, the panel of devices and a steering column disconnect at first negative, and then positive the plug from the storage battery and wait 2 minutes It will exclude unapproved disclosing of pillows of safety and operation натяжителей seat belts which can put physical injuries.
|
Removal of the panel of devices make as follows:
Switch off ignition and disconnect a wire of "weight" from the storage battery.
Remove panels of furnish from the panel of devices and the central console.
Remove a combination of devices.
Disconnect an electric socket from a pillow of safety of the forward passenger and on models since 2001 of release, remove a safety pillow.
Remove a radio receiver from the panel of devices.
Remove a control panel the conditioner.
Remove the bottom left panel of furnish and the panel amplifier. Turn out bolts of fastening of a steering column and reject it downwards from the panel of devices.
|
|
Fig. 14.56. An arrangement of electric sockets of the panel of devices on models with 2001 годамоделях since 2001
|
Mark and disconnect electric sockets from the panel of devices (
fig. 14.56).
|
|
Fig. 14.57. An arrangement of the main electric sockets of the panel of devices on models till 2001
|
On models till 2001 disconnect the main electric sockets from each party of the panel of devices and turn out two bolts of fastening of wires of weight in the centre of the panel of devices (
fig. 14.57).
|
|
Fig. 14.58. An arrangement of bolts, screws and nuts of fastening of the panel of devices on models till 2001
|
|
|
Fig. 14.59. An arrangement of bolts of fastening of the amplifier of the panel of devices on models till 2001
|
Turn out all bolts, screws and nuts of fastening of the panel of devices to a car body, then lift the panel and through a door, take from the car (
fig. 14.58). It is a laborious work and to carry out it it is necessary with the assistant. Also, probably, it is required to turn out bolts and to remove the amplifier of the panel of devices (
fig. 14.59).
Installation of the panel of devices make in sequence, return to removal.