Removal of the lock of a door make as follows:
Lift against the stop door glass, then remove an upholstery and пылевлагозащитную a film from a door.
Through an aperture in the internal panel of a door release plastic clips and disconnect from the lock of draught of the external and internal handle of a door and the lock cylinder. All draughts fasten to the lock plastic clips which it is necessary with effort to remove and take away from draught, then to extend draught from a clip aperture.
On doors with electric blocking of locks disconnect electric sockets from the lock.
|
|
Fig. 14.29. An arrangement of screws of fastening of the lock of a door to a door on models till 2001
|
|
|
Fig. 14.30. An arrangement of screws of fastening of the lock of a door to a door on models since 2001
|
Turn out screws of fastening of the lock to a door and through an aperture in the internal panel of a door remove the lock (
fig. 14.29,
14.30).
On models since 2001 turn out the screw of fastening of the internal handle, separate the handle from a door and remove the lock together with the internal handle.
Installation make in sequence, return to removal, taking into account the following:
Fix пылевлагозащитную a film, having established it without folds and ruptures. The surface on which the film is pasted пылевлагозащитная, should be ideally pure.