|
THE PREVENTION
Cars are equipped by safety systems (SRS), including pillows of safety and натяжители seat belts. Before work about gauges of blow, the panel of devices and a steering column disconnect at first negative, and then positive the plug from the storage battery and wait 2 minutes It will exclude unapproved disclosing of pillows of safety and operation натяжителей seat belts which can put physical injuries.
|
Removal of forward wings make следущим in the image:
Tighten a lay brake and block back wheels an emphasis.
Loosen the nuts of fastening of a forward wheel.
Lift a forward part of the car and establish on support.
Remove a forward wheel.
Open a cowl.
On models till 2001 remove the panel located under a headlight.
On models since 2001 remove a radiator lattice.
Remove a forward bumper (see above).
Remove a headlight.
|
|
Fig. 14.12. An arrangement of clamps and screws (the bottom clamps are not shown) fastenings грязезащитного a guard of an arch of a forward wheel
|
Release clamps, turn out screws and remove
грязезащитный a guard of an arch of a forward wheel (
fig. 14.12).
If the right wing acts in film, remove the radio receiver aerial. At removal of the left wing remove a rack of support of a cowl in open position.
Open a forward door and turn out the top bolt of fastening of a wing to a car body.
Turn out the bottom bolt of fastening of a wing to a car body.
|
|
Fig. 14.13. An arrangement of a bolt of fastening of the wing, an accessible wheel from under an arch
|
Turn out a bolt of fastening of the wing, accessible from under a wheel arch (
fig. 14.13).
|
|
Fig. 14.14. An arrangement of a bolt of fastening of a forward part of a wing
|
Turn out a bolt of fastening of a forward part of a wing (
fig. 14.14).
|
|
Fig. 14.15. An arrangement of bolts of fastening of the top part of a forward wing
|
Turn out 3 bolts of fastening of the top part of a forward wing (
fig. 14.15).
Remove a wing from the car, thus be careful not to scratch the panels of a body close to a wing.
Installation make in sequence, return to removal, taking into account the following:
Establish a forward wing on the car, combine apertures under screws and clamps and fix it.
At wing installation check up, that backlashes between a wing and a cowl, and also between a wing and a forward door were uniform on all length.