Replacement make in a following order:
– Remove a transmission;
– Remove a drive flywheel/plate;
– Note position and depth of installation of an old sealing ring;
|
|
Fig. 3.96. Extraction of a back sealing ring of a cranked shaft
|
– The special tool or the big screw-driver get a sealing ring from the block of cylinders (
fig. 3.96). For simplification of removal of a sealing ring a sharp knife cut off a working edge from the reinforced basis on all perimetre of a sealing ring. Be cautious not to damage a nest of a sealing ring and a cranked shaft;
– Clear a nest of a sealing ring and a neck of a cranked shaft. Grease with engine oil an external surface and a working edge of a sealing ring;
|
|
Fig. 3.97. Use send and a hammer for installation of a back sealing ring of a cranked shaft
|
– Tubular
оправкой, with external diameter a bit smaller external diameter of a ring, establish a sealing ring on a place (
fig. 3.97). Check up that the ring is established without a warp and on the same depth, as earlier established ring;
– Establish a drive flywheel/plate;
– Establish a transmission.