Тойота РАВ4-Toyota RAV4
1. Car operation
2. Maintenance service
3. Engines
   Engine repair 3S-FE without its removal from the car
   Engine repair 1AZ-FE without its removal from the car
      The general data
      Specifications
      Installation of the piston of the first cylinder in the top dead point (ВМТ)
      Cover of a head of the block of cylinders
      System of change of phases timing (VVT — Variable Valve Timing)
      Drive chain газораспределительного the mechanism and an asterisk
      Camshafts and pushers of valves
      Inlet collector
      Final collector
      Head of the block of cylinders
      Pulley/gasitel of fluctuations
      Forward sealing ring of a cranked shaft
      The oil pallet
      The oil pump
      Flywheel / a drive plate
      Back sealing ring of a cranked shaft
      Support of the power unit
   Diagnostics and preparation of the engine for major repairs
4. Cooling and air-conditioning systems
5. Fuel system and system of release of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. A transmission
10. A kardannyj shaft and shaft of a drive of driving wheels
11. Brake system
12. A suspension bracket
13. A steering and a running gear
14. A body
15. An electric equipment
Electric equipment schemes




Toyota RAV4>> Engines>> Engine repair 1AZ-FE without its removal from the car>> Final collector
Removal
Removal of a final collector spend on the cold engine in a following order:
– Switch off ignition and disconnect a wire of "weight" from the storage battery;
– Tighten a lay brake and establish an emphasis under back wheels;
– Lift a forward part of the car and establish on support;
– Remove грязезащитный a guard of a motor compartment;

Fig. 3.77. Fastening of a reception exhaust pipe to a final collector: 1 – bolts; 2 – bolts of fastening of the bottom part of a final collector; 3 – oxygen gauges


– Put on bolts 1,2 (fig. 3.77) and springs of fastening of a reception exhaust pipe to a final collector the means facilitating them отворачивание. After impregnation of bolts, turn out them and separate from a collector a reception exhaust pipe, thus be careful not to damage gauges of oxygen 3;
– Turn out bolts of fastening of the bottom braces of a final collector;
– Disconnect electric sockets from oxygen gauges;
– From a motor compartment remove the top thermofilter of a final collector. There is also a bottom thermofilter which is attached from below a final collector, and it is not required to be removed;

Fig. 3.78. An arrangement of nuts of fastening of a final collector


– Turn out nuts (fig. 3.78) and bolts and, having pulled from a head of the block of cylinders, remove a final collector with a lining.
Installation
Installation make in a following order:
– A scraper remove the rests of an old lining and adjournment of soot with привалочных surfaces of a final collector and a head of the block of cylinders;
– If the new final collector is established, it is necessary to rearrange from an old collector on a new bottom thermofilter;
– Establish a new lining of a final collector on a head of the block of cylinders according to inscriptions available on it and signs;
– Establish a final collector and fix its nuts. Tighten nuts in some passes, since the centre and further on a spiral.
The further installation spend to sequences, return to removal.
Start up the engine and check up on absence of leaks of the fulfilled gases.