Тойота РАВ4-Toyota RAV4
1. Car operation
2. Maintenance service
3. Engines
   Engine repair 3S-FE without its removal from the car
   Engine repair 1AZ-FE without its removal from the car
      The general data
      Specifications
      Installation of the piston of the first cylinder in the top dead point (ВМТ)
      Cover of a head of the block of cylinders
      System of change of phases timing (VVT — Variable Valve Timing)
      Drive chain газораспределительного the mechanism and an asterisk
      Camshafts and pushers of valves
      Inlet collector
      Final collector
      Head of the block of cylinders
      Pulley/gasitel of fluctuations
      Forward sealing ring of a cranked shaft
      The oil pallet
      The oil pump
      Flywheel / a drive plate
      Back sealing ring of a cranked shaft
      Support of the power unit
   Diagnostics and preparation of the engine for major repairs
4. Cooling and air-conditioning systems
5. Fuel system and system of release of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. A transmission
10. A kardannyj shaft and shaft of a drive of driving wheels
11. Brake system
12. A suspension bracket
13. A steering and a running gear
14. A body
15. An electric equipment
Electric equipment schemes




Toyota RAV4>> Engines>> Engine repair 1AZ-FE without its removal from the car>> The oil pallet
Removal
Removal make in a following order:
– Switch off ignition and disconnect a wire of "weight" from the storage battery;
– Tighten a lay brake and establish an emphasis under back wheels;
– Lift a forward part of the car and establish on support;
– Remove грязезащитный a guard of a motor compartment;
– Merge from the engine engine oil and turn out the oil filter;
– Remove the index (щуп) oil level;

Fig. 3.89. An arrangement of bolts of fastening of the oil pallet


– Turn out bolts (fig. 3.89) and remove the oil pallet. If the oil pallet sits strongly, separate it from the block of cylinders, having inserted between them a screw-driver edge, thus do not damage привалочные a surface of the pallet and the block of cylinders.
Installation
Firm plastic or wooden scraper clear of the rests of old hermetic привалочные surfaces of the oil pallet and the block of cylinders and clear their solvent.
Check up that carving apertures for bolts of fastening of the oil pallet in the block of cylinders pure and have no carving damages.
Check up a flange of the oil pallet, especially about apertures for bolts, on presence of defects. If necessary remove available teases or notches.
Check up fastening маслозаборной tubes and absence in it of cracks. If маслозаборная the tube acted in film, clear it and establish with a new sealing ring or a lining. Check up on absence of pollution the mesh filter маслозаборника.
Put on привалочную a surface of the oil pallet a layer of hermetic RTV in diameter of 5 mm.

       THE NOTE
The oil pallet is necessary for establishing during 5 mines after hermetic drawing.

Establish the oil pallet on the block of cylinders and fix bolts, having tightened them by hand at this stage. Consistently on a circle, in some passes, tighten bolts the moment 9 Nm.
The further installation is spent to sequences, return to removal, taking into account the following.
Before pouring of engine oil wait 1 ч that hermetic has had time to harden.
Establish the new oil filter and fill in in the engine engine oil.
Start up the engine and check up on absence of leaks.