Removal of the pump of the amplifier of a steering for models till 2001 make as follows.
Switch off ignition and disconnect a wire of "weight" from the storage battery.
Syringe pump out a liquid from a tank of the amplifier of a steering.
Establish under a motor compartment the reception pallet for liquid gathering.
Tighten a lay brake and block back wheels an emphasis.
Lift the car on the lift, remove protection of a motor compartment.
Remove forward section of system of release of the fulfilled gases.
|
|
Fig. 13.15. An arrangement of the left bolts of fastening of a cross-section beam on models till 2001
|
Remove tips of steering draughts from rotary fists and turn out a bolt of fastening of the steering mechanism to a cross-section beam, then turn out bolts and remove a cross-section beam of a forward suspension bracket (
fig. 13.15 see
).
|
|
Fig. 13.17. An arrangement swivel and tightening bolts of fastening of the pump of the amplifier of a steering
|
Loosen the шарнирный and tightening bolts, move the pump of the amplifier of a steering to the engine and remove a belt of a drive of the pump (
fig. 13.17).
Loosen the a collar also disconnect a hose of return of a liquid from the pump;
|
|
Fig. 13.18. A reversing of the union of a delivery hose (1) from the pump of the amplifier of a steering
|
накидным a key turn out the union of a delivery hose from the pump (
fig. 13.18).
Disconnect two vacuum hoses from the pump.
|
|
Fig. 13.19. An arrangement of bolts of fastening of an arm of the pump of the amplifier of a steering on models till 2001
|
Turn out bolts of fastening of an arm of the pump and remove the pump (
fig. 13.19);
If necessary turn out nuts and remove the pump from an arm.
Pump installation spend to sequences, return to removal, taking into account the following.
Adjust tension of a belt of a drive of the pump.
Add a liquid in a tank of the amplifier of a steering and remove air from hydraulic system.
Removal of the pump of the amplifier of a steering for models since 2001 make as follows:
Switch off ignition and disconnect a wire of "weight" from the storage battery.
Syringe pump out a liquid from a tank of the amplifier of a steering.
Establish under a motor compartment the reception pallet for liquid gathering.
Remove a belt of a drive of the pump of the amplifier of a steering.
Tighten a lay brake and block back wheels an emphasis.
Loosen the nuts of fastening of the right forward wheel.
Lift a forward part of the car and establish on support.
Remove the right forward wheel and грязезащитный a guard of an arch of the right forward wheel.
Disconnect an electric socket from the gauge of pressure of the amplifier of a steering.
Turn out a hollow bolt and disconnect a delivery hose from the pump.
Loosen the a collar also disconnect a hose of return of a liquid from the pump.
|
|
Fig. 13.20. An arrangement top () and bottom () bolts of fastening of the pump of the amplifier of a steering on models since 2001
|
Turn out the bottom bolt, then
loosen the the top bolt and remove the pump of the amplifier of a steering from the engine (
fig. 13.20).
Pump installation spend to sequences, return to removal, taking into account the following:
At installation of a hollow bolt of fastening of a delivery hose use new sealing linings.
Establish a wheel, screw nuts, lower the car and tighten nuts of fastening of a wheel.
Establish a belt of a drive of the pump and adjust its tension.
Add a liquid in пополнительный a tank of the amplifier of a steering and remove air from hydraulic system.