Removal of a steering column make следущим in the image:
Switch off ignition, disconnect a wire of "weight" from the storage battery and wait for 2 mines before carrying out of the further work.
Establish wheels for movement directly forward.
Remove a steering wheel, then turn a key in the ignition lock in position LOCK to block a steering shaft from rotation, otherwise the spiral wire of a pillow of safety can be damaged.
Remove the bottom panel of furnish, under a steering column.
Remove casings of a steering column.
Disconnect electric sockets from a plait of wires of a steering column.
|
|
Fig. 13.7. An arrangement of a coupling bolt of fastening of a steering shaft to the universal hinge
|
Note position of the universal hinge in relation to a steering shaft and turn out a coupling bolt (
fig. 13.7).
|
|
Fig. 13.8. A steering column: 1 – the universal hinge; 2 – a steering column; 3 – the combined switch; 4 – a cover №2 steering wheels; 5,8 – screws Torx; 6 – a steering wheel; 7 – a safety pillow; 9 – a cover №3 steering wheels; 10 – a protective plate of a steering column; 11 – the top casing of a steering column; 12 – the bottom casing of a steering column; 13 – the bottom upholstery of the panel of devices; 14 – the handle of opening of the lock of a cowl; 15 – an air line; 16 – the bottom insert of the panel of devices; 17 – an intermediate shaft
|
|
|
Fig. 13.9. An arrangement of bolts of fastening of a steering column on models since 2001
|
Turn out bolts of fastening of a steering column, then lower and, having pulled back, be convinced that it keeps nothing (
fig. 13.8,
13.9). Separate an intermediate shaft from a steering shaft and remove a steering column.
Installation of a steering column make следущим in the image:
Insert the bottom end of a steering shaft into a nest of the universal hinge of an intermediate shaft and screw, but do not tighten, bolts of fastening of a steering column.
Tighten bolts of fastening of a steering column the moment 25 Nm.
Screw a coupling bolt of fastening of the universal hinge to a steering shaft and tighten its moment 26
Nm (
fig. 13.7 see
).
The further installation make in sequence, return to removal.