Replacement of covers of the steering mechanism make as follows:
Tighten a lay brake and block back wheels an emphasis.
Loosen the nuts of fastening of a forward wheel.
Lift a forward part of the car and establish on support.
Remove a forward wheel.
Remove a tip of steering draught and turn out a counternut.
|
|
Fig. 13.12. Cutting of a collar of fastening of a protective cover to the steering mechanism
|
Cut or
loosen the and remove collars of fastening of a protective cover to steering draught and the steering mechanism (
fig. 13.12).
Remove a protective cover, shifting it on steering draught.
Before installation of a new cover wrap up a sticky tape a carving part of steering draught for an exception of damage of a cover.
Pulling on steering draught, establish a new protective cover and fix its collars.
Remove a sticky tape and screw on steering draught a tip of steering draught.
Insert a pin of the spherical hinge of a tip of steering draught into a rotary fist and fix its nut and a pin.
Establish a wheel, screw nuts, lower the car and tighten nuts of fastening of a wheel.
Check up and if necessary adjust corners of installation of wheels.