Тойота РАВ4-Toyota RAV4 1. Car operation 2. Maintenance service 3. Engines 4. Cooling and air-conditioning systems 5. Fuel system and system of release of the fulfilled gases 6. Ignition system 7. The monitoring system and decrease in toxicity of the fulfilled gases 8. Coupling 9. A transmission    The general data    Specifications    Transmission repair    The repair and adjusting works which are carried out on cars with a mechanical transmission    The repair and adjusting works which are carried out on cars with an automatic transmission       Diagnostics of an automatic transmission       Replacement of sealing cuffs       Check, adjustment and replacement of a cable of management throttle заслонкой       Replacement and adjustment of a cable of the selector       Replacement and adjustment of the switch of blocking of a starter (PNP)       Check of system of blocking of the lever of the selector and the ignition lock       Removal and installation of an automatic transmission on models with one leading bridge       Removal and installation of an automatic transmission on all-wheel drive models 10. A kardannyj shaft and shaft of a drive of driving wheels 11. Brake system 12. A suspension bracket 13. A steering and a running gear 14. A body 15. An electric equipment Electric equipment schemes Toyota RAV4>> Transmission>> The repair and adjusting works which are carried out on cars with an automatic transmission>> Replacement and adjustment of the switch of blocking of a starter (PNP) Adjustment If engine start is possible in any other position, except P and N, adjust the switch of blocking of a starter. Tighten a lay brake and block back wheels. Lift a forward part of the car and establish it on support. Remove a mudguard of a motor compartment. Establish the selector lever in car salon in position N. Loosen the bolts of fastening of the switch of blocking of a starter. Establish the lever of a choice of transfers on a transmission in position N. Fig. 9.23. Combination of a line (1) on the switch of blocking of a starter with a flute (2) on a shaft of the lever of a choice of transfers on models with one leading bridge of release 1996 and 1997 and all-wheel drive models with 1996 for 2001 Fig. 9.24. Combination of a line (2) on the switch of blocking of a starter with a flute (3) on a shaft of the lever of a choice of transfers and an arrangement of bolts (1) fastenings of the switch on models of release since 2001 Combine a line on the switch of blocking of a starter with a flute on a shaft of the lever of a choice of transfers (fig. 9.23, 9.24). Tighten bolts of fastening of the switch of blocking of a starter and check up its work. If engine start-up is still possible in any other position, except P and N, replace the switch. Replacement Switch off ignition and disconnect a wire of "weight" from the storage battery. Tighten a lay brake and block back wheels. Lift a forward part of the car and establish it on support. Remove a mudguard of a motor compartment. Establish the selector lever in car salon in position N. Turn away a nut and remove the lever of a choice of transfers from a transmission shaft. Disconnect an electric socket from the switch. Turn out bolts and remove the switch from a shaft of a choice of transfers of a transmission. Combine a line on the switch with a flute on a shaft of a choice of transfers and establish the switch on a shaft. Turn the switch before line combination on the switch of blocking of a starter with a flute on a shaft of the lever of a choice of transfers (fig. 9.23, 9.24 see). Tighten bolts of fastening of the switch and connect to it an electric socket. Establish on a shaft the lever of a choice of transfers and connect "a weight" wire to the storage battery. Check up switch work. Engine start-up should be possible only in position of selector "P" and N.