Тойота РАВ4-Toyota RAV4 1. Car operation 2. Maintenance service 3. Engines 4. Cooling and air-conditioning systems 5. Fuel system and system of release of the fulfilled gases 6. Ignition system 7. The monitoring system and decrease in toxicity of the fulfilled gases 8. Coupling 9. A transmission    The general data    Specifications    Transmission repair    The repair and adjusting works which are carried out on cars with a mechanical transmission    The repair and adjusting works which are carried out on cars with an automatic transmission       Diagnostics of an automatic transmission       Replacement of sealing cuffs       Check, adjustment and replacement of a cable of management throttle заслонкой       Replacement and adjustment of a cable of the selector       Replacement and adjustment of the switch of blocking of a starter (PNP)       Check of system of blocking of the lever of the selector and the ignition lock       Removal and installation of an automatic transmission on models with one leading bridge       Removal and installation of an automatic transmission on all-wheel drive models 10. A kardannyj shaft and shaft of a drive of driving wheels 11. Brake system 12. A suspension bracket 13. A steering and a running gear 14. A body 15. An electric equipment Electric equipment schemes Toyota RAV4>> Transmission>> The repair and adjusting works which are carried out on cars with an automatic transmission>> Replacement and adjustment of a cable of the selector        PREVENTIONS Cars are equipped by safety systems (SRS), including pillows of safety and натяжители seat belts. Before work about gauges of blow, the panel of devices and a steering column disconnect at first negative, and then positive for the plug from the storage battery and wait about two minutes. It will exclude unapproved disclosing of pillows of safety and operation натяжителей seat belts which can cause a trauma. Replacement Being under the car, remove the bottom mudguard of a motor compartment. Lift a forward part of the car and establish it on support. Turn away a nut of fastening of a cable of the selector and disconnect it from the lever of a choice of transfers on the forward party of a transmission. Remove a clip and remove a cover of a cable from an arm on a transmission. Remove the central console. Disconnect a cable from the bottom part of the lever of the selector, then compress clamps and separate a cover of a cable from a casing of the lever of the selector. Take a cable from a sealing ring in a partition of a motor compartment. Installation make in sequence, return to removal. After installation adjust a selector cable. Adjustment Loosen the a nut of fastening of a cable of the selector to the lever of a choice of transfers on the forward party of a transmission. Fig. 9.20. Positions P, R and N the lever of a choice of transfers on a transmission on models with one leading bridge of release 1996 and 1997 and all-wheel drive models of release with 1996 for 2001 Fig. 9.21. Positions P, R and N the lever of a choice of transfers on a transmission on models with one leading bridge of release with 1998 for 2001 Fig. 9.22. Positions P, R and N the lever of a choice of transfers on a transmission on models of release since 2001 Establish the lever of a choice of transfers on a transmission in position N (fig. 9.20, 9.21, 9.22). Establish the selector lever in car salon in position N. The assistant should hold the selector lever in salon of the car with small pressure towards position R, at this time tighten a nut of fastening of a cable of the selector to the lever of a choice of transfers on a transmission. Moving the selector lever, be convinced that the lever of a choice of transfers also moves to corresponding positions. In each position of the lever of the selector try to get the engine. The starter should join only at positions of the lever of selector "P" and N.