Removal of a cable of an accelerator make as follows:
Switch off ignition and disconnect a wire of "weight" from the storage battery.
|
|
Fig. 5.22. Easing of a counternut of fastening of a cover of a cable to throttle knot
|
Loosen the a counternut of fastening of a cover of a cable to throttle knot (
fig. 5.22).
Turn the lever of throttle knot and a needle or пассатижами remove a cable of an accelerator from a groove in the lever.
Disconnect a cable of an accelerator from an accelerator pedal.
Take a cable of an accelerator from a partition in a motor compartment.
Installation of a cable of an accelerator spend to sequences, return to removal. Be convinced that before installation of a cable of an accelerator in a partition of a motor compartment the condensing ring is established.
For adjustment of a cable of an accelerator execute the following:
– Turn away an adjusting nut on 3 mm from a cable arm;
– Eliminate any sagging of a cable;
– Tighten a counternut and check up a deflection of a cable accelerators between the lever of throttle knot and a cover of a cable which should make 9–12 mm. If the deflection leaves for the specified limits, loosen the a counternut and, rotating an adjusting nut, establish a demanded deflection;
– After adjustment of a cable of an accelerator, the assistant should press and release an accelerator pedal, thus the lever of throttle knot should turn from an emphasis against the stop. Check up that the accelerator cable moves smoothly, without jammings.