Тойота РАВ4-Toyota RAV4
1. Car operation
2. Maintenance service
3. Engines
4. Cooling and air-conditioning systems
5. Fuel system and system of release of the fulfilled gases
   The general data
   Technical characteristics of system of injection of fuel
   Sbrasyvanie pressure in fuel system
   The general check of fuel system
   The fuel pump
   Regulator of pressure of fuel
   The gauge of level of fuel
   Fuel tank
   The case of the air filter
   Accelerator cable
   Electronic system of injection of fuel
   Демпфер fuel pulsations on models since 2001
   Distributive fuel highway and atomizers
   System of release of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. A transmission
10. A kardannyj shaft and shaft of a drive of driving wheels
11. Brake system
12. A suspension bracket
13. A steering and a running gear
14. A body
15. An electric equipment
Electric equipment schemes




Toyota RAV4>> Fuel system and system of release of the fulfilled gases>> Fuel tank
Removal of a fuel tank make as follows.
Dump pressure in fuel system.
Remove a stopper from a jellied mouth of a fuel tank therefore pressure in a fuel tank will be levelled with the atmospheric.
Switch off ignition and disconnect a wire of "weight" from the storage battery.
If in a fuel tank there is a fuel, pump out it. Fuel pumping out spend the special pump.
Lift the car on the lift.
Remove back and central parts of system of release of the fulfilled gases.
On all-wheel drive cars remove propeller a shaft.

Fig. 5.16. Places of connection of fuel pipelines and a tube of return of steams of fuel to a fuel tank


Disconnect from a fuel tank fuel pipelines, a tube of return of steams of fuel and a jellied mouth (fig. 5.16). Close fuel pipelines plastic stoppers that will exclude вытекание fuel and pollution of fuel system.
Jack, through wooden брусок support a fuel tank.

Fig. 5.17. An arrangement of bolts of fastening of basic tapes of a fuel tank


Fig. 5.18. A fuel tank of cars till 2001 of release: 1 – a lining; 2 – the block of the fuel pump/gauge of level of fuel; 3 – a clamp of fastening of a tube; 4 – a cover of a fuel tank; 5 – a lining; 6 – the main tube of a fuel tank; 7 – the valve of the control of filling; 8 – the gauge of level of fuel; 9 – a protective cover of the valve of the control of filling; 10 – a thick fuel pipe; 11 – a tube for air removal; 12 – a protective plate; 13 – a tube; 14 – a jellied mouth; 15 – a jellied mouth; 16 – a cover of a jellied mouth; 17 – a lock ring; 18 – collars; 19 – an inlet fuel hose; 20 – a protective plate; 21 – a fuel tank; 22 – a basic tape of a fuel tank; 23 – a protective plate; 24 – protective plates


Turn out bolts of fastening of basic tapes of a fuel tank (fig. 5.17, 5.18).
Lower a fuel tank so that it was possible to disconnect an electric socket from the block of the fuel pump/gauge of level of fuel.
Take a fuel tank from under the car.

       THE PREVENTION
Even in an empty fuel tank there are steams of fuel which are explosive, therefore be careful.

Any repair of a fuel tank or jellied mouth should be carried out by the expert who has experience of performance of critical and potentially dangerous works. Even after clearing and washing of a fuel tank in it there are explosive steams of fuel.
On cars of later releases the fuel tanks made of plastic which are not subject to repair are established.
The removed fuel tank should be located far from the open fire, the sparkling devices, open fire-dangerous light devices and smoking places.
Installation of a fuel tank spend to sequences, return to removal.

Fig. 5.19. The air filter on models till 2001: 1 – an accelerator cable; 2 – a tank of hydraulic system of the amplifier of a steering; 3 – a filtering element of the air filter; 4 – a broad tank; 5 – the relay of the control of sliding; 6 – an electric socket of the gauge of temperature of air arriving in the engine; 7 – a hose of compulsory ventilation картера (PCV); 8 – high-voltage wires; 9 – an air hose; 10 – a cover of the air filter; 11 – the case of the air filter; 12 – the block of the relay №2; 13 – a cable of management throttle заслонкой; 14 – a lining; 15 – a tube of giving of fuel; 16 – a lining


Fig. 5.20. The air filter on models since 2001: 1 the ignition coil; 2 – an electric socket of the coil of ignition; 3 – the case of the air filter; 4 – a filtering element of the air filter; 5 – an arm of the air filter


Removal and installation of the case of the air filter make as follows (fig. 5.19 and 5.20):
Release spring clips and uncover and a filtering element of the air filter.
On models till 2001 disconnect an electric socket from the relay of the control of the sliding placed sideways of a cover of the air filter.
On models since 2001 disconnect a branch pipe of an air inlet from a cover of the air filter.

Fig. 5.21. An arrangement of screws of fastening of the case of the air filter


Turn out 3 screws and remove the case of the air filter (fig. 5.21).
Installation of the case of the air filter spend to sequences, return to removal.
Installation of the case of the air filter spend to sequences, return to removal.