Тойота РАВ4-Toyota RAV4
1. Car operation
2. Maintenance service
3. Engines
4. Cooling and air-conditioning systems
   The general data
   Specifications
   Service and repair of system of cooling
      The thermostat
      The radiator fan
      Radiator and broad tank
      The water pump
      The gauge of the index of temperature of a cooling liquid
      Thermoswitch of the fan of a radiator
      The electric motor of the fan of a heater
      Knot of management of heating and air conditioning systems
      Heater radiator
   Check and service of a central air of air
5. Fuel system and system of release of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. A transmission
10. A kardannyj shaft and shaft of a drive of driving wheels
11. Brake system
12. A suspension bracket
13. A steering and a running gear
14. A body
15. An electric equipment
Electric equipment schemes




Toyota RAV4>> Cooling and air-conditioning systems>> Service and repair of system of cooling>> The electric motor of the fan of a heater
       THE PREVENTION
Cars are equipped by safety systems (SRS), including pillows of safety and натяжители seat belts. Before work about gauges of blow, the panel of devices and a steering column disconnect at first negative, and then positive the plug from the storage battery and wait 2 minutes It will exclude unapproved disclosing of pillows of safety and operation натяжителей seat belts which can cause traumas.

Switch off ignition and disconnect a wire of "weight" from the storage battery.
The heater fan is located in car salon over the right foot of the forward passenger.
On cars of release till 2001 remove a ware box.

Fig. 4.21. The fan electric motor: And — an electric socket; In — the fan electric motor


Disconnect an electric socket from the fan engine (fig. 4.21).
Turn out screws of fastening and take out downwards the fan from a casing.
If the fan engine is subject to replacement, remove a lock ring, remove and rearrange the fan on the new engine, fix its lock ring.
The further installation make in sequence, return to removal.
Check up work of the electric motor of the fan.