ремонт мерседес вито

Тойота РАВ4-Toyota RAV4
1. Car operation
2. Maintenance service
3. Engines
4. Cooling and air-conditioning systems
5. Fuel system and system of release of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. A transmission
10. A kardannyj shaft and shaft of a drive of driving wheels
11. Brake system
12. A suspension bracket
   The general data
   Specifications
   Rack of a forward suspension bracket
   Dismantling and assemblage of an amortisation rack
   The forward stabilizer of cross-section stability
   The bottom lever of a forward suspension bracket
   Rotary fist and nave of a forward wheel
   The back stabilizer of cross-section stability
   The shock-absorber of a back suspension bracket
   Levers of a back suspension bracket
      Replacement of the top cross-section lever
      Replacement of the bottom cross-section lever
      Replacement of the longitudinal lever
   Spring of a back suspension bracket
   Nave and the bearing of a back wheel
13. A steering and a running gear
14. A body
15. An electric equipment
Electric equipment schemes




Toyota RAV4>> Suspension bracket>> Levers of a back suspension bracket>> Replacement of the longitudinal lever
Remove a spring.
Turn out bolts and remove arms of a brake tube and a cable of a lay brake from the longitudinal lever of a back suspension bracket.
Remove a nave of a back wheel together with the bearing. Remove from the longitudinal lever a protective casing of a back brake together with brake колодками and a soft wire fix on a body.

Fig. 12.24. An arrangement of the adjusting cam defining relative position of the longitudinal lever and an arm


Paint or marker note position of the adjusting cam defining relative position of the longitudinal lever and an arm (fig. 12.24).
Turn out шарнирный a bolt and separate the longitudinal lever of a back suspension bracket from an arm.
Check up a plug condition on absence of deterioration, stratification and rubber hardening. If necessary replace the plug with servicing deports.
Installation make in sequence, return to removal, taking into account the following.
According to earlier put labels establish an adjusting cam of the longitudinal lever defining relative position and an arm.
Before a tightening swivel a bolt of fastening of the longitudinal lever to an arm raise a jack a back part of the lever to establish the lever in position in which it should be when the car costs on wheels.
In this position of the lever tighten all nuts and bolts of fastening of a back suspension bracket.
Check up and if necessary adjust corners of installation of back wheels.