Fig. 12.21. An arrangement of nuts of fastening of the top and bottom cross-section levers to a back rotary fist on models till 2001
On models till 2001 remove pin
, turn away a nut and separate a pin of the spherical hinge of the top lever from a back rotary fist (fig. 12.21
). If the pin of the spherical hinge does not separate manually, take it by means of a stripper.
Fig. 12.22. An arrangement of a bolt of fastening of the top lever to an arm on the longitudinal lever of a back suspension bracket on models since 2001
On models till 2001 turn away a nut and take a bolt of fastening of the top lever to an arm on the longitudinal lever of a back suspension bracket (fig. 12.22
Turn away a nut and take шарнирный a bolt of internal fastening of the top lever.
Remove the top cross-section lever from the car.
Check up a lever condition. On it there should not be cracks and deformations. The plug should not have deterioration, stratification and rubber hardening.
On models till 2001 check up a condition of the spherical hinge of the top cross-section lever for what fix the lever in a vice. Reject against the stop in one and other party a pin of the spherical hinge, then screw a nut on a pin. A Dinamometrichesky key turn a pin of the spherical hinge (one turn for 2–4), and on the fifth turn measure a twisting moment проворачивания which should be not less than 0,7 Nm. Otherwise replace the top cross-section lever.
Installation make in sequence, return to removal.