Removal of the main cylinder of coupling make as follows:
Switch off ignition and disconnect a wire of "weight" from the storage battery.
Under the panel of devices disconnect a pusher from the top part of a pedal of coupling. The pusher fastens a pin with a head on the one hand and an aperture for pinа, on the other hand.
If the car is equipped by cruise-control system remove a casing of the block of management of the cruise-control, turn out 3 screws and take the block aside.
By means of a clip press on small distance from a tank of brake system a hose of giving of a liquid to the main cylinder of coupling.
Disconnect a hose from the main cylinder of coupling and, rags, collect the flowed out brake liquid.
|
|
Fig. 8.2. An arrangement of a connecting nut of fastening of a tube to the working cylinder of coupling
|
Turn out a connecting nut and disconnect from the main cylinder of coupling a tube transferring pressure of a liquid to the working cylinder (
fig. 8.2).
Отворачивание a connecting nut spend cutting накидным a key not to damage a side on a nut.
Under the panel of devices from outside the driver turn out 2 nuts and remove the working cylinder of coupling.
|
PREVENTIONS
The brake liquid used in hydraulic system of brakes, is poisonous, therefore at its hit on a skin it is necessary to wash out immediately this place a water considerable quantity.
Besides, the brake liquid dissolves a paint and plastic, therefore at liquid hit on a paint and varnish covering of the car wash out its considerable quantity of water.
|
Installation of the main cylinder of coupling make as follows:
Establish the main cylinder of coupling on a partition of a motor compartment and fix nuts, having tightened them by hand.
Connect to the main cylinder of coupling a tube and fix its connecting nut.
Connect to the main cylinder of coupling a hose from a filling tank.
Tighten nuts of fastening of the main cylinder of coupling by the moment 12 Нм.
Connect a pusher to a coupling pedal.
Remove a clip which pressed a hose connecting a tank of brake system with the main cylinder of coupling.
Add a brake liquid in a tank of brake system and remove air from a hydraulic drive of coupling.