Тойота РАВ4-Toyota RAV4
1. Car operation
2. Maintenance service
3. Engines
   Engine repair 3S-FE without its removal from the car
   Engine repair 1AZ-FE without its removal from the car
   Diagnostics and preparation of the engine for major repairs
      Specifications for check
      The general data
      Check of pressure of oil
      Compression check in engine cylinders
      Diagnostics of the engine by means of the vacuum gauge
      Alternative to engine major repairs
      The general recommendations about removal and engine installation
      Removal and engine installation
      Sequence of dismantling of the engine
      Start and обкатка the engine after major repairs
4. Cooling and air-conditioning systems
5. Fuel system and system of release of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. A transmission
10. A kardannyj shaft and shaft of a drive of driving wheels
11. Brake system
12. A suspension bracket
13. A steering and a running gear
14. A body
15. An electric equipment
Electric equipment schemes




Toyota RAV4>> Engines>> Diagnostics and preparation of the engine for major repairs>> Sequence of dismantling of the engine
The engine is recommended to be assorted at the special stand, in the absence of the stand establish the engine on an equal horizontal platform.
If the restored engine it is necessary to remove all hinged units is got, and to establish them subsequently precisely in the same order on the new engine. Such units concern:
– Elements of the control of issue of the fulfilled gases;
– The ignition distributor (only on engines till 1997);
– High-voltage wires and ignition coils;
– The thermostat and a thermostat cover;
– The water pump (only on engines since 2001);
– Bypass a branch pipe of system of cooling;
– Inlet and final collectors;
– The oil filter;
– Support;
– A flywheel / a drive plate.
If the block of cylinders of an incomplete complete set it is necessary to remove and establish on the new engine is got:
– A gear belt or a drive chain газораспределительного the mechanism;
– A head of the block of cylinders;
– The oil pump;
– The water pump (only on engines till 2001);

Fig. 3.99. Places of drawing of a layer of hermetic (1) on bottom картер and an arrangement of a sealing ring before its installation on the block of cylinders on models since 2001


Fig. 3.100. An arrangement of bolts of fastening bottom картера: And — long bolts; In — short bolts


– Bottom картер (fig. 3.99, 3.100);
– Forward covers;
– The oil pallet;
– A cover of a head of the block of cylinders.