Тойота РАВ4-Toyota RAV4 1. Car operation 2. Maintenance service 3. Engines 4. Cooling and air-conditioning systems 5. Fuel system and system of release of the fulfilled gases 6. Ignition system 7. The monitoring system and decrease in toxicity of the fulfilled gases 8. Coupling 9. A transmission 10. A kardannyj shaft and shaft of a drive of driving wheels 11. Brake system 12. A suspension bracket    The general data    Specifications    Rack of a forward suspension bracket    Dismantling and assemblage of an amortisation rack    The forward stabilizer of cross-section stability    The bottom lever of a forward suspension bracket    Rotary fist and nave of a forward wheel    The back stabilizer of cross-section stability    The shock-absorber of a back suspension bracket    Levers of a back suspension bracket    Spring of a back suspension bracket    Nave and the bearing of a back wheel       Removal       Installation 13. A steering and a running gear 14. A body 15. An electric equipment Electric equipment schemes Toyota RAV4>> Suspension bracket>> Nave and the bearing of a back wheel>> Installation Establish a nave on a back rotary fist and screw four bolts or nuts. After all bolts or nuts are screwed, tighten their moment specified in specifications. On models with one leading bridge of release 1996 and 1997 and all-wheel drive models till 2001 establish brake pads and connect a brake tube to the working brake cylinder. On all-wheel drive models establish a power shaft. Establish a brake drum and a wheel. On models with one leading bridge of release 1996 and 1997 and all-wheel drive models till 2001 remove air from brake system. Establish a wheel, screw nuts, lower the car and tighten nuts of fastening of a wheel. On all-wheel drive models tighten a nut of fastening of a shaft of a drive of a wheel to a nave the moment specified in specifications, and fix it pinом.