On all-wheel drive models loosen the a nut of fastening of a shaft of a drive to a nave of a back wheel.
Block forward wheels an emphasis. Lift a back part of the car and establish it on support. Remove a wheel.
Remove a brake drum. On models with one leading bridge of release 1996 and 1997 and all-wheel drive models till 2001 remove brake pads, disconnect a cable of a lay brake from a protective casing of a back brake and disconnect a brake tube from the working brake cylinder.
On all-wheel drive models remove a shaft of a drive of a wheel.
|
|
Fig. 12.25. Отворачивание bolts of fastening of a nave to a back rotary fist
|
Through apertures in a nave turn out four bolts (on models till 2001) or nuts (on models since 2001) nave fastenings to a back rotary fist (
fig. 12.25).
Remove a nave of a back wheel together with the bearing. On models with one leading bridge of release 1996 and 1997 and all-wheel drive models till 2001 together with a nave remove a protective casing of a back brake. On models with one leading bridge of release with 1998 on 2001 repeatedly screw one of bolts for support of a protective casing of a back brake.
On models with one leading bridge of release 1996 and 1997 and all-wheel drive models till 2001 it is possible выпрессовать the old bearing from a nave and запрессовать new. This work is necessary for carrying out at servicing deport. On all other models the nave with the bearing is made as the uniform block, and at bearing failure it is required to replace a nave in gathering.
On models with one leading bridge of release since 2001 with ABS remove the gauge of frequency of rotation from an old nave and establish on a new nave.