Tighten a lay brake and block back wheels an emphasis.
Loosen the nuts of fastening of a forward wheel. Lift a forward part of the car and establish it on support. Remove a forward wheel.
Turn out a bolt of fastening of an arm of a brake hose to a rack of a forward suspension bracket. In the presence of ABS turn out bolts of fastening of clips of wires and separate a plait of wires of the gauge from a rack.
On models since 2001 disconnect draught of the stabilizer of cross-section stability from an arm on a rack.
Note mutual position of the bottom part of a rack and a rotary fist that at installation not to break wheel disorder. Also note position of heads of bolts because on a part of cars special adjusting bolts were established.
|
|
Fig. 12.1. Отворачивание nuts of fastening of the bottom part of a rack of a forward suspension bracket to a rotary fist
|
Turn on two nuts and a hammer and
выколоткой beat out two bolts of fastening of the bottom part of a rack to a rotary fist (
fig. 12.1).
Separate the bottom part of a rack from a rotary fist.
|
THE PREVENTION
Be careful not to damage an internal SHRUS of a power shaft. Also prevent falling of a rotary fist outside of the car, it can lead to a stretching or rupture of a brake hose.
|
|
|
Fig. 12.2. An arrangement of nuts of fastening of the top part of a rack of a forward suspension bracket to a car body
|
Supporting a rack from below, turn out three nuts of fastening of the top part of a rack to a car body (
fig. 12.2). Take a rack from under a car wing.