|
|
Fig. 11.44. Height of installation of a pedal of a brake: 1 – a pusher; 2 – the stoplight switch; Х – height of installation of a pedal of a brake
|
Measure height of installation of a pedal of a brake which should be in the limits resulted in specifications and on
fig. 11.44. If necessary adjust height of installation of a pedal of a brake as follows.
Remove the bottom casing of a steering column.
Disconnect an electric socket from the stoplight switch.
Loosen the a counternut of the switch of a stoplight also turn out it.
Loosen the a pusher counternut.
Adjust height of installation of a pedal of a brake, rotating a pusher in one or other party.
Tighten a pusher counternut.
Establish the switch of a stoplight and wrap it till the moment of a contact of the case of the switch with the terminator of a course of a pedal of a brake.
Turn out the stoplight switch on one turn.
|
|
Fig. 11.45. Backlash measurement between a carving part of the case of the switch and the terminator of a course of a pedal of a brake: And = 0,5–2,4 mm
|
Measure distance between a carving part of the case of the switch and the terminator of a course of a pedal of a brake which should be in limits of 0,5-2,4 mm (
fig. 11.45).
Tighten a counternut of the switch of a stoplight.
Connect an electric socket to the stoplight switch.
Check up that stoplights light up by pressing of a pedal of a brake and die away at it release.