Тойота РАВ4-Toyota RAV4 1. Car operation 2. Maintenance service 3. Engines 4. Cooling and air-conditioning systems 5. Fuel system and system of release of the fulfilled gases 6. Ignition system 7. The monitoring system and decrease in toxicity of the fulfilled gases 8. Coupling 9. A transmission 10. A kardannyj shaft and shaft of a drive of driving wheels 11. Brake system    The general data    Specifications    Antiblocking system of brakes (ABS)    Replacement of lobbies brake pads    Replacement of a support of a forward brake    Check and replacement of brake disks    Replacement back brake pads    Replacement of the working brake cylinder    Replacement of the main brake cylinder    Replacement of sealing rings of a tank of brake system    Replacement of brake tubes and hoses    Prorolling of a hydraulic drive of brakes    Check and replacement of the vacuum amplifier of brakes    Adjustment of a lay brake    Replacement of cables of a lay brake       Replacement of a back cable       Replacement of a forward cable    Adjustment of position of a pedal of a brake    Check and replacement of the switch of a stoplight 12. A suspension bracket 13. A steering and a running gear 14. A body 15. An electric equipment Electric equipment schemes Toyota RAV4>> Brake system>> Replacement of cables of a lay brake>> Replacement of a back cable The back cable of a lay brake connects brake mechanisms of back wheels to the jack. Remove pressure in fuel system and disconnect a wire of "weight" from the storage battery. Block forward wheels an emphasis. Loosen the nuts of fastening of a back wheel. Lift a back part of the car and establish it on support. Release the lever of a lay brake. Remove a brake drum. Remove brake pads and disconnect a cable of a lay brake from the lever fixed on back brake колодке. Fig. 11.43. An arrangement of bolts of fastening of a cover of a cable of a lay brake to a protective casing of a back brake Turn out two bolts of fastening of a cover of a cable of a lay brake and extend it from a protective casing of a back brake (fig. 11.43). Remove a fuel tank and the thermofilters located over system of release of fulfilled gases. Turn out bolts of fastening of clips of a cable of a lay brake to the car bottom. Disconnect a forward part of a cable of a lay brake from the jack and remove it from the car. Installation make in sequence, return to removal, taking into account the following. Grease a forward part of a cable of a lay brake and connect it to the jack. Adjust a cable of a lay brake.