Тойота РАВ4-Toyota RAV4
1. Car operation
2. Maintenance service
3. Engines
4. Cooling and air-conditioning systems
5. Fuel system and system of release of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. A transmission
10. A kardannyj shaft and shaft of a drive of driving wheels
11. Brake system
   The general data
   Antiblocking system of brakes (ABS)
   Replacement of lobbies brake pads
   Replacement of a support of a forward brake
   Check and replacement of brake disks
   Replacement back brake pads
   Replacement of the working brake cylinder
   Replacement of the main brake cylinder
   Replacement of sealing rings of a tank of brake system
   Replacement of brake tubes and hoses
      Replacement of a forward brake hose
   Prorolling of a hydraulic drive of brakes
   Check and replacement of the vacuum amplifier of brakes
   Adjustment of a lay brake
   Replacement of cables of a lay brake
   Adjustment of position of a pedal of a brake
   Check and replacement of the switch of a stoplight
12. A suspension bracket
13. A steering and a running gear
14. A body
15. An electric equipment
Electric equipment schemes

Toyota RAV4>> Brake system>> Replacement of brake tubes and hoses>> Replacement of a forward brake hose
Loosen the nuts of fastening of a wheel also lift the car on the lift. Remove a wheel.
For reduction of losses of a brake liquid uncover a tank of brake system, close a mouth of a tank polyethylene and again screw a cover. It is necessary that the cover tightly closed a tank.

Fig. 11.38. A reversing of a connecting nut of fastening of a brake tube to a brake hose

On an arm turn out a connecting nut of fastening of a brake tube to a brake hose (fig. 11.38). A nut turn out cutting накидным a key, and the second key keep a brake hose from проворачивания.
Пассатижами remove an U-shaped clip of fastening of a brake hose to an arm.
On a support turn out a hollow bolt of fastening of a brake hose.
Turn out a bolt of fastening of an arm of a brake hose to a rack of a forward suspension bracket and remove a hose from the car.
Installation make in sequence, return to removal, taking into account the following.
Be convinced that the brake hose is not overwound and does not concern mobile parts of a suspension bracket. At fastening of a brake hose to a support use new sealing linings.
Remove air from hydraulic brake system.