Grease working edges of a sealing cuff of a transmission. Insert a forward part карданного a shaft into a transmission and screw, but do not tighten, bolts of fastening of an arm of the basic bearing карданного a shaft to the car bottom.
Adjust position of an arm of the basic bearing
карданного a shaft so that the distance between a cover of the hinge and a ledge on a back part
карданного a shaft was in limits of 65,5-70,5 mm, and the distance between a back part of the basic bearing and a back part of a rubber support should be in limits of 11,5-13,5 mm (
fig. 10.12,
10.13). Tighten bolts of fastening of an arm of the basic bearing
карданного a shaft the moment 37
Nm.