Wrap up Slots the internal end of a shaft of a drive a sticky tape not to damage a protective cover about sharp sides шлицев a shaft.
Pull a collar and a protective cover over a drive shaft.
Establish трипоид on Slots a shaft of a drive and fix its lock ring. Grease трипоид and an internal surface of the case of the hinge. Insert the hinge into the case and fill with its rests of greasing.
Put on the hinge a protective cover, thus check up, that cover seats were established in the grooves intended for them.
|
|
Fig. 10.8. A place of measurement of length of a shaft of a drive
|
Measure length of a shaft of a drive which should correspond to the length resulted in specifications (
fig. 10.8).
Fix a protective cover collars, a screw-driver preliminary having raised internal edge of a cover for alignment of pressure of air under a cover.
|
|
Fig. 10.9. Application of the special tool for collar fastening: 1 – a protective cover; 2 – the special tool; 3 – a collar clip
|
The special tool is necessary for fastening of collars (
fig. 10.9). Tool sponges establish on corners of a clip of a collar and in this position tighten sponges the screw.
Establish a drive shaft on the car.