Remove a shaft of a drive of a wheel.
Through wooden бруски clamp a drive shaft in a vice.
Check up radial люфт the SHRUS which specifies in deterioration of details of the hinge. Check up smoothness of a course on a full range of movement for each SHRUS. If the protective cover has been torn, remove the SHRUS, disassemble, clear and check up it on absence of damages because of loss of greasing and possible pollution by extraneous particles.
Small screw-driver release clips, loosen the collars of fastening of a protective cover and shift them on a shaft.
|
|
Fig. 10.5. Removal of a protective cover from an internal SHRUS of type трипоид
|
Screw-driver edge hook and shift external edge of a cover from an internal SHRUS. If the protective cover is torn, cut off it. Remove internal edge of a cover and shift it from a type SHRUS
трипоид (
fig. 10.5).
Трипоид represents
трехплечий the hinge on which each shoulder the roller from the tempered steel is fixed.
With paint or marker mark mutual position of a shaft of a drive and трипоида.
|
|
Fig. 10.6. Removal of the spring lock ring fixing трипоид on a shaft
|
The special tool remove the spring lock ring fixing
трипоид on a shaft (
fig. 10.6).
|
|
Fig. 10.7. Use of a hammer and brass выколотки for removal трипоида from a drive shaft
|
Hammer through brass
выколотку bring down
трипоид from a drive shaft, thus be careful not to damage
Slots a shaft and rollers
трипоида (
fig. 10.7).
If work is carried out on right приводном to a shaft, note an arrangement of the balance weight and remove it. For balance weight removal, probably, it is necessary to take advantage of a press.