Тойота РАВ4-Toyota RAV4 1. Car operation 2. Maintenance service 3. Engines 4. Cooling and air-conditioning systems 5. Fuel system and system of release of the fulfilled gases 6. Ignition system 7. The monitoring system and decrease in toxicity of the fulfilled gases 8. Coupling 9. A transmission 10. A kardannyj shaft and shaft of a drive of driving wheels 11. Brake system 12. A suspension bracket    The general data    Specifications    Rack of a forward suspension bracket    Dismantling and assemblage of an amortisation rack    The forward stabilizer of cross-section stability    The bottom lever of a forward suspension bracket    Rotary fist and nave of a forward wheel    The back stabilizer of cross-section stability    The shock-absorber of a back suspension bracket       Removal       Installation    Levers of a back suspension bracket    Spring of a back suspension bracket    Nave and the bearing of a back wheel 13. A steering and a running gear 14. A body 15. An electric equipment Electric equipment schemes Toyota RAV4>> Suspension bracket>> The shock-absorber of a back suspension bracket>> Removal Block forward wheels an emphasis. Lift a back part of the car and establish it on support. Remove a wheel. Jack raise the longitudinal lever of a back suspension bracket to compress a spring and to unload the shock-absorber. Fig. 12.18. Removal of a cover of a lateral upholstery for access to a nut of the top fastening of the shock-absorber on models till 2001 Fig. 12.19. Removal of a cover of a lateral upholstery for access to a nut of the top fastening of the shock-absorber on models since 2001 From within the car uncover a lateral upholstery for access to a nut of the top fastening of the shock-absorber (fig. 12.18, 12.19). Turn away a nut and remove two holder and the plug from a shock-absorber rod. Fig. 12.20. An arrangement of a bolt of the bottom fastening of the back shock-absorber Turn out a bolt of the bottom fastening and remove the shock-absorber from the car (fig. 12.20).