The back stabilizer of cross-section stability is established on models since 2001
Block forward wheels an emphasis. Lift a back part of the car and establish it on support.
|
|
Fig. 12.16. An arrangement of a nut of fastening of draught of the stabilizer of cross-section stability to the stabilizer
|
Turn away a nut of fastening of draughts of the stabilizer of cross-section stability (
fig. 12.16). At
отворачивании nuts of fastening of spherical hinges of draught of the stabilizer
шестигранным a key keep from
проворачивания a pin of the spherical hinge.
|
|
Fig. 12.17. An arrangement of nuts of fastening of clips, крепящих the stabilizer of cross-section stability to a car body
|
Turn out bolts of fastening of clips with plugs,
крепящих the stabilizer of cross-section stability to a car body (
fig. 12.17).
Remove the stabilizer of cross-section stability from the car.
Remove from the stabilizer basic plugs and check up their condition.
Check up a condition of spherical hinges of draughts of the stabilizer. For this purpose remove them from the car and fix in a vice (fig. 10). Reject against the stop in one and other party a pin of the spherical hinge, then screw a nut on a pin. A Dinamometrichesky key turn a pin of the spherical hinge (one turn for 2–4), and on the fifth turn measure a twisting moment проворачивания which should be not less than 0,04 Nm. Otherwise replace draught of the stabilizer.
Wire brush clear stabilizer zones on which basic plugs are established.