Tighten a lay brake and block back wheels an emphasis.
Loosen the nuts of fastening of a forward wheel. Lift a forward part of the car and establish it on support. Remove a forward wheel.
Take pin from a pin of the spherical hinge and loosen the a nut of fastening of the spherical hinge to a rotary fist.
|
|
Fig. 12.14. Use of a stripper for branch of a pin of the spherical hinge from a rotary fist
|
Mount or stripper separate a pin of the spherical hinge from a rotary fist (
fig. 12.14). Turn on, as far as possible, a nut of fastening of a pin of the spherical hinge. The backlash between a pin of the spherical hinge and the SHRUS of a shaft of a drive of a wheel small also does not allow to turn away a nut at one time. Therefore operate as follows: turn away a nut on 1–2 turns and wring out downwards the spherical hinge, again turn away a nut on 1–2 turns and wring out downwards the spherical hinge, and so to full
отворачивания nuts.
|
|
Fig. 12.11. An arrangement of a bolt and nuts of fastening of the spherical hinge to the bottom lever of a forward suspension bracket
|
Turn out a bolt and two nuts of fastening of the spherical hinge to the bottom lever of a forward suspension bracket (
fig. 12.11 see
). Mount separate the spherical hinge from the bottom lever of a forward suspension bracket and remove from the car.
Insert a pin of the spherical hinge into an aperture of a rotary fist and screw a nut on a pin.
Establish the bottom lever on the spherical hinge and fix its bolt and nuts, having tightened their moment specified in specifications.
Tighten a nut of fastening of a pin of the spherical hinge to a rotary fist and establish new pin. If the aperture in a pin for pinа does not coincide with grooves on a nut, tighten a nut towards a tightening while grooves on a nut will coincide with an aperture.
The further installation make in sequence, return to removal.