Тойота РАВ4-Toyota RAV4 1. Car operation 2. Maintenance service 3. Engines 4. Cooling and air-conditioning systems 5. Fuel system and system of release of the fulfilled gases 6. Ignition system 7. The monitoring system and decrease in toxicity of the fulfilled gases 8. Coupling 9. A transmission 10. A kardannyj shaft and shaft of a drive of driving wheels    The general data    Specifications    Shaft of a drive of forward wheels    Shaft of a drive of back wheels on all-wheel drive cars    Replacement of protective covers of hinges of a shaft of a drive of a wheel    Kardannyj shaft    The basic bearing карданного a shaft       Removal       Installation    Sealing cuffs of back main transfer    Differential on all-wheel drive cars 11. Brake system 12. A suspension bracket 13. A steering and a running gear 14. A body 15. An electric equipment Electric equipment schemes Toyota RAV4>> Kardannyj shaft and shaft of a drive of driving wheels>> The basic bearing карданного a shaft>> Installation Fig. 10.15. Position of installation of the basic bearing on a forward part карданного a shaft Establish the basic bearing and a washer on a forward part карданного a shaft (fig. 10.15). Establish a flange on propeller a shaft, having combined the labels put before removal, and fix its new nut with a washer. Clamp propeller a shaft in a vice with soft sponges and tighten a nut of fastening of the basic bearing. A hammer and a chisel Tighten the a nut. Connect forward and back parts карданного a shaft, having combined the labels put before removal, and fix bolts, having tightened them at the given stage by hand. Grease working edges of a sealing cuff of a transmission. Insert a forward part карданного a shaft into a transmission and screw, but do not tighten, bolts of fastening of an arm of the basic bearing карданного a shaft to the car bottom. Connect the back universal hinge карданного a shaft to a flange of the main reverse gear, having combined the labels put before removal, and tighten nuts and bolts the moment 74 Nm. When the assistant presses a brake pedal, tighten bolts of fastening of two parts карданного a shaft. Adjust position of the basic bearing карданного a shaft.